Urgent Automation is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply.
Product comes with Urgent Automation's 1-year warranty.
Rockwell Disclaimer: The product is used surplus. Urgent Automation is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because Urgent Automation is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, Urgent Automation makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. Urgent Automation also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. Urgent Automation also makes no representations as to your right to install any such firmware on the product. Urgent Automation will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
Urgent Automation is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply.
Product comes with Urgent Automation's 1-year warranty.
The GHB3020 is a circuit breaker. It belongs with the GHB Series C. Manufacturing and production of this circuit breaker is done by Eaton Cutler Hammer. It has three poles & a fixed thermal-magnetic trip. The power comes through wired source. 20 Ampere current rating is the default current rating. The default voltage rating is 250 Volts DC and 480 Volts AC. It has a 50 to 60 Hertz Frequency, is panel mounted, and comes in a G Frame. It has trip units which cannot be interchanged. The operational temperature of 40 degrees is set during the manufacturing. The GHB3020 has a rating of 65 K Ampere IC at 240 Volts AC and 14 K Ampere at 480/277 Volts AC for interruption. The GHB3020 comes inside a molded case and is considered a very safe device. It is 6.6 inches in length, 3.8 inches in height, and 3.8 inches in width, and weighs 1.75 pounds. It offers protection for low voltage systems where electric demand is very high. It is also suitable for reverse feed purpose and offers protection for conductors against high overloads, protects motor and motor starters against short circuits. It has a reset actuator lever. It is rated SWD (Switching duty) for fluorescent lighting conditions. HACR rating has been obtained for this variant. It comes with both line & load terminals.
The GHB3020 is UL listed and is CSA certified. One-year warranty on installation date and 18 months on shipping date is available. It is widely used in factory areas and commercial industries.
Part Number/Catalog No. | GHB3020 |
Product Type | Molded Case Circuit Breaker |
Series | C |
Frame | G |
Type | Bolt-On Panelboard |
Pole(s) | 20 |
Trip Amps | 14 |
kA @ 125 VDC | 4 x 3 x 2.63 in. |
Part Number/Catalog No. | GHB3020 |
Product Type | Molded Case Circuit Breaker |
Series | C |
Frame | G |
Type | Bolt-On Panelboard |
Pole(s) | 20 |
Trip Amps | 14 |
kA @ 125 VDC | 4 x 3 x 2.63 in. |